Jim.The.STEAM.Clown - AM/PM - 30 - Cut out the Frame for the Back Bug

Next Steps:

• I need to look at changing the motors for a higher gear ratio, so they will run slower
• I need to pick a method to sense the edge of the table
• Right now it runs with an Arduino Controller, but I was thinking of adding a Raspberry Pi too

What jim.The.STEAM.Clown Did Today:

• Created  a frame.  I looked at lots of 2 wheeled robots, and then sketched a design on plastic.  I then cut this frame out.  I have not pulled the paper off the plastic yet, as I may want to draw on the spots where I drill more holes... but eventually I'll pull off the paper.  But it’s my first car robot… WoHooooooooooo