Jim.The.STEAM.Clown - AM/PM - 30 - WoHooooo got the motors running

Next Steps:

1. I need to look at changing the motors for a higher gear ratio, so they will run slower
2. I need to pick a method to sense the edge of the table
3. Right now it runs with an Arduino Controller, but I was thinking of adding a Raspberry Pi too

What jim.The.STEAM.Clown Did Today:

• Mounted the original motors.  These may be too low of a gear ratio for a table top bot.  They seem to work fine for on the ground.  
• I soldered on wires to the motors and then tested that they worked with a 5 V DC power supply.  They worked.
• I then connected the motor controller, and tested the Arduino code.  I’ll add links later to the Resource page.